It usually means bend but would be written 15b 16
Meaning bend to 16
2 Likes
That is what I thought but without a bend parameter I wasn’t sure. I am used to seeing bends as an arrow, up or down, with a 1/2 or full designation. Could the 15b15b15b indicate a bend less than 1/2? Would that even sound good?
2 Likes
@ChasetheDream
If it’s a blues it may be a 1/4 bend. What song is it?
Can you post that part of the tab?
2 Likes
Thanks for the prompt replies, Stitch. It is much appreciated. The song is For What It’s Worth by Buffalo Springfield. The tab I was inquiring about was one an individual had put together in an attempt to blend the 3 guitars together to be played by a single guitar. I looked at the Tab for the song on this site and found that the guitars use bends of !/4, 1/2 and full, both up and down. Definitely going to take some time to sort the various riffs and try to work them into a piece played by a single musician. In the future I will look at Justin’s tabs first!
2 Likes
This question doesn’t relate to any of Justin’s theory course. I hope I’ve posted in the right place?
I know I have the answers to my questions somewhere in my brain, but the librarian is out to lunch right now.
I have Justin’s Rhythm Reading and can’t find the answer there.
What are the notations circled in red and arrowed? I think it’s timing, perhaps like dotted notes/ties for fingerstyle, a way of writing 1 + etc ? The wiggly line, can’t remember at all.
Thankyou.
@Richard_close2u Richard you’ve sent me orf on another trajectory after the discoveries in the last one.
1 Like
Hi Maggie. Consider the markings under each bar first. These are a representation of what would appear in standard notation as vertical lines of the stave. Bars 1 and 2 have the exact same. Two vertical markers connected by a single beam are eighths. A stand alone vertical is a quarter. A dot means the note(s) are increased in length by half of the indicated duration. In these two bars are:
a] two eighths connected by a beam
b] an eighth
c] a dotted quarter
d] a quarter
I have written bar two out in standard notation with TAB in Guitar Pro. I have placed it above your TAB. I have also written some annotations to help make sense of it.
Take this analysis and you can see that Bar 3 is four pairs of eighths then bar 4 is three pairs of eighths then a quarter.
As for the other question, the squiggly-wiggle wibbly-wobbly indicates that those notes are played with some slight, steady fretting-hand vibrato added. Guitar Pro shows it in a similar manner.
For vibrato applied with a whammy bar, Guitar Pro has a different style of graphic.
Hope that helps.
Richard
3 Likes
Sorry I put the question in the wrong place, didn’t use the right keywords in my search. Thankyou for sorting that out.
Oooh Richard what a thorough, clearly explained, brain satisfying response. 
Thankyou and thank you for the time it’s taken to put this together and share it. The standard notation makes sense in its familiar way. I’ve copied your tutorial into my note book. I’m also going to write out a couple of bars in the style you have so generously shared to help it stick.
I hope you are finding resolution to the recent ending, and that far better opportunities are opening up for you.
1 Like
This comment in the text seem completely backwards!
“ Here’s another way to think about it. A tab stave shows the guitar strings as you’re looking down on them when you’re playing. :)”
In tab the top line is the 1st string, the thinnest string….but when I play my guitar, I’m looking down at the strings and the first string is the thickest string!
What am I missing?
2 Likes
Welcome to the forum James
When you look down at the fret board the first string you
see is indeed the E (6th) string, the lowest in tone.
When you look at tab the lowest line represents the E (6th)
the lowest on the stave.
This is also why when you play the notes going towards the
body it’s going up the neck because the notes are going up
in pitch.
2 Likes
Hello @jtoomeyj and welcome to the Community.
Were you to take a print out of TAB and place it flat on a desk, then place your guitar flat on the desk in the manner you play it, with you sitting at the desk, both would have the low E / thickest / 6th string nearest to you. The orientation of the TAB will not always be flat depending on whether you read it on a computer screen, a music stand or other. But the same principle applies regardless of the orientation.
Hope that helps.
Cheers 
| Richard_close2u | JustinGuitar Official Guide
3 Likes
Trust @Richard_close2u to put this in such a simple and succinct way. 
I don’t know why but I could understand TAB right from the off and I can’t remember how I reconciled it in my head. I think I thought in terms of pitch with the bottom line being the lowest, top line being the highest. But to try and explain it to someone who saw the contradiction I found it hard to make it simple for them lol
2 Likes
Justin mentioned there are a lot of inaccurate tabs on the Internet. When I can’t find a tab in Justin’s collection where does he recommend I look?
1 Like
@suborder Justin used to give a shout out to Songsterr on the old site, I don’t recall seeing that recommendation carried over to the new site but it is probably still a good and valid recommendation.
Cheers 
| Richard_close2u | JustinGuitar Official Guide, Approved Teacher & Moderator
1 Like
My apologies if I missed this in the video or elsewhere. What do the curved lines above notes in the Tab mean?
1 Like
Hi Firas, the curved lines going from one note to another are hammer-ons and flick-offs.
2 Likes
Thank you for the clarification James.
A little advanced for me now, but something to consider later when I reach those techniques in the course.
2 Likes
They can have different meanings.
Hammer-on and Flick-off as @socio states.
Also, a sustained note within a bar or across bars.
Look:
The first curved line is a note that is sustained.
The second is a hammer-on (also showing H between the TAB and notation).
The third is a sustained note.
Here is that same section without the standard notation above.
Here is a slightly busier piece (with then without standard notation above). See if you can analyse this yourself.
Note that P indicates a flick-off (pull-off).
Cheers
| Richard | JustinGuitar Approved Teacher, Official Guide & Moderator
2 Likes
Whilst a lot of tab does have the H and P letters to indicate a hammer-on or pull-off, I have come across tabs which just show the curved line.
The way to tell, in this case is, if the second note is a higher pitch then it’s a hammer-on; if it’s a lower pitch then it’s a pull-off.
And, of course, if it’s the same note, then it’s a sustained note.
Cheers,
Keith
2 Likes
Your timing is both impeccable and slightly eerie Richard 
I’ve been working on Module 10 of Grade 2 this past week where Hammer-ons are introduced! Thanks for the detailed breakdown and examples, I really appreciate it 
Let’s see if I’ve got it:
Pull-off > Pull-off > Hammer-on > Sustain > Hammer-on > Sustain
@Majik Thanks for the extra tips Keith That makes sense, much appreciated.
1 Like